Please retain your proof of purchase. Ensure your purchase information is safe by registering your product online at www.methven.com/nz/register.

THIS DOCUMENT PERTAINS TO ALL PRODUCT PURCHASED FROM APRIL 2020

GWA provides the following warranty for all Methven, Flexispray and Echo products purchased in Australia or New Zealand from authorised GWA resellers for use in domestic residential (indoor) or commercial (indoor) installations (Goods). Commercial installations are all non-residential installations including hotels, motels, gyms, clubs, factories, schools, hospitals, restaurants and aged care facilities. This warranty is in addition to GWA’s responsibility to customers under all other statutory and regulatory requirements.


WARRANTY PERIODS


 

WARRANTY STATEMENT

(a) Our Goods come with guarantees that cannot be excluded under the Australian and New Zealand Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage.

(b) If during the applicable warranty period set out in the tables above (Warranty Periods), a Good has a material defect which arose in the course of manufacture then, subject to the warranty conditions below being met, you may submit a warranty claim to GWA;
- by email [email protected]. Please complete the warranty claim form here
- by calling Customer Care New Zealand on Ph: 0800 804 222
GWA may require you to return the Good, and you must pay the expenses for such return.

(c) GWA will (at its cost) either repair or replace (at GWA’s option) the Good at an equivalent value of the product purchased if it is discovered that the product contains a material defect which arose during manufacture. GWA will pay the expense for shipment of the repaired or replaced Good to you.

(d) Should any warranty claim be made and attended to by a GWA authorised Service Agent and that in the opinion of the Service agent or GWA, the problem was from a faulty installation or use of the products in conjunction with products of another manufacturer or from some other cause other than a manufacturing defect of the products for which GWA is responsible, GWA reserves the right to charge a service fee for each service staff attending the premise where products have been installed.

(e) A Lifetime Replacement Warranty applies for the lifetime of the original purchaser.

The Warranty Statement does not apply to any other brands marketed and sold by GWA.

 

WARRANTY CONDITIONS

The warranty set out in the Warranty Statement above (other than sections 1(a)) is subject to the following conditions, and accordingly shall not apply if:

(a) The Good was not new as at the date of purchase or proof of purchase details (such as invoice, receipt or transaction record) are not provided.

(b) There is a failure to follow installation instructions, evidence cannot be provided that the Good was installed by a licensed plumber or the Good is used other than in with product specifications. This includes operating conditions specified for temperature and pressure.

(c) Repair work is performed on the relevant Good by a person other than GWA, its authorized service agents or any plumber who has not received authorisation from GWA prior to proceeding with the work.

(d) Applicable statutes or regulations relating to public health are not observed and the product must not have been damaged by misuse, accident or neglect.

(e) Standards or regulations governing sewerage, plumbing, water supply and gas applicable to the location of the particular plumbing installation are not observed. This includes (without limitation) the Australian Standards (AS/NZ 3500.1 Plumbing and Drainage Part 1: Water services) which specify that the main water supply pressure to any new home, extension or renovation must be limited to 500kPa. The recommended continuous operating pressure for tapware is between 150-500kPa.

(f) Harsh detergents or abrasive cleaners are used on any finishes of the Good.

(g) The product must not contain excessive debris (in-line filters must be installed).

(h) The Good has discolouration, corrosion or rusting from ‘hard’ water and/or other environmental factors.

(i) Adequate access to products, fittings and fixtures to undertake extended warranty repairs is required. GWA will not be responsible for any consequential damage or costs where adequate access to product fittings and fixtures is not accessible.

 

NEFA VALVES WARRANTY

(a) NEFA valves are not fit for purpose after a 5 year period from manufacture date (as per coded stamp on each product).

(b) The date of manufacture is marked on the valve, represented by a five digit number. The first two digits of the date of manufacture refer to the last two digits of the year of manufacture. The remaining three digits refer to the numerical day of the year in which the valve was manufactured (for example, 30 June 2018 would be represented as 18181).

(c) Methven will (at its cost) replace any NEFA valve to the original purchaser if it is purchased with less than 12 months remaining of the 5 year expiration period from manufacture date (as per coded stamp on each product).

 

For purchases made prior to 1st April 2020

Click here to view the warranty statement.